User manual

Restore Factory Settings

Factory Settings are:

- Communication channel: USB

- Protocol: BAUM

- Auto-power-off: after 15 Minutes

- Sound: ON

- Bluetooth Name: “BAUM SuperVario(xxxxxxxx)”,

xxxxxxxx is the serial number

- Bluetooth Pincode: “1234”

- Bluetooth class: “Display”

5.2.8 Quit menu and save settings

Press one of the cursor routing keys above the word “off”. When quitting the menu all

changes will be saved automatically, and the Braille display will resume its normal user

status.

After you left the system menu, you may want to re-enter it. This can be accomplished by

turning the device off and on again or even simpler by double clicking the power button.

5.3 Display rotation:

If you press the middle buttons beside the display D2D5 simultaneously, the display is

rotated by 180 degree. The function of the buttons is turned around too.

5.4 Self-test

The Self-test function can only be accessed from the advanced System Menu.

In the System Menu, press the first two and the last two cursor routing keys on the Braille

display (SuperVario2 40: P1 P2 P39 P40) simultaneously to launch self-test. The dots of each

Braille cell will be activated one after the other and then cleared; the pressed keys will also

be displayed. As soon as data have been transferred to the Braille display the Self-test will

end and the display will return to normal.

Once Self-test has been launched, dot B1 then B2, B3, B7, B4, B5, B6, B8 etc. will be set on

each cell until all 8 dots are set. They will then be cleared one by one until all are cleared.

This process is then repeated.

Press and hold the keys as follows:

D1 to set dots B2B5 in the first cell