User manual

8
Power Indicator Light
The Power indicator light is located above the Power Button. The light glows steady
green when the device is on; the light blinks when the device is in standby mode; the
light is off when the device is turned off. It glows red when the device is off and is being
charged, and glows orange when the device is on and is being charged.
Power Up
Press the Power Button to power up the device. The start-up process is indicated by a
series of beeps and takes approximately 90 seconds. When the Ace Plus is ready, you
will hear the announcement: “Main Menu: Scan and Read.”
Standby Mode
When operating the device on battery power, after five minutes of inactivity, the Ace
Plus goes into standby mode, to consume less power. A short series of tones indicates
when the device is going into this mode, and then a blinking power indicator light
indicates the device is on standby.
Press the Power Button to wake up the Ace Plus and return it to the active mode.
It takes about 15 seconds for the Ace Plus to “wake up.” After a series of beeps, the
device is ready to operate. It wakes up in the same spot where it was left off going into
sleep mode. To check which menu option you are in, press the Center Daisy Button. To
return to the Main Menu, press the Home Button.
Power Down
Press and hold the Power Button for approximately three seconds to power down the
Ace Plus completely. You will hear a short series of beeps as it powers off.
Checking the Battery Charge Status
To quickly check the battery status, press the round Center Daisy Button. An
announcement will tell the battery status and whether or not you are connected to a
Network.
The battery status is also given in the Settings sub-menu under Status. To get to the
Status menu from the Main Menu, scroll to and select Settings. Then scroll to and
select Status. The percentage of available battery charge is announced and also