Operation Manual

28
DRAIN HOSE
•
Fitting the drain hose.
Remove elbow from the drum and insert into
the free end of the drain hose.
Install drain hose either a the siphon trap or,
using the elbow, hang over the edge of a
wash basin or sink (see Fig.). Small hand
basins are not suitable.
Max. drain height: 1.25 m
Use identical hose type if extension is
required.
Secure the connections with hose clamps.
Max. drain hose length 2.50 m.
Important:
drain hose must be installed without kinks
and must be secured against dropping during
operation.
CONNECTION TO THE MAINS
•
Observe local utility company regulations.
•
The appliance must be connected to the
mains exclusively by means of a socket with
an earth connection in accordance with
established regulations. Earthing is required
by law. The manufacturer declines all
responsibility for injury to persons or pets, or
damage to property caused by non-
compliance.
•
The data concerning voltage, consumption
and necessary fuse are supplied on the
inside of the appliance door.
•
The mains connection cable may only be
replaced by original power cable by
authorised After-Sales Service.
•
The appliance conforms to European safety
regulations, EC directive 93/68/EC.
•
A pulse current sensitive device must be
used in connection with this appliance if a
residual current breaker is used, regardless
of whether it is an existing installation or a
new installation.
•
Do not use extension leads or multiple
sockets.
INSTALLATION INSTRUCTIONS