Use and care guide

18
Press the UP or DOWN key to set the
desired delay of the programme end.
Press Start / Pause - the countdown of
the delay starts. The display indicates
the default programme duration
of the selected programme, and
underneath the set “Finish in” period.
The Start/Pause button and the Finish
in button light up; the colon between
hours and minutes of the Finish in
period blinks.
The programme starts automatically,
in time to be nished at the end of the
delay period.
The programme duration can be
inuenced by certain factors, mainly
by the humidity level of the laundry.
For that reason, the programme
duration is recalculated and adapted
in certain programme phases.
During these phases, the display
shows an animation. This can lead
to an earlier or later programme end
than originally set with the Finish
in function. In that case, the display
indicates, after programme end, that
the programme has nished earlier or
later.
The maximum selectable delay is
23:30 hours. To exit the settings mode
without setting a Finish in period,
select “__:__”.
To cancel the delay:
Either press Start/Pause to cancel
the delay. To start the selected
programme immediately, press Start/
Pause again.
Or press and hold On/O to cancel the
complete programme setting.
SETTINGS The following settings can be
changed:
Language: to adapt the display
language
Key tones: to adapt the tone when
pressing a button
Cycle end alert: to adjust the tone
signal at the end of the programme or
switch it o completely
Display contrast: to regulate the
contrast of the display text
Water conductivity: to adapt to
your local water conductivity; refer
to section FIRST TIME USE for more
information.
Remember last used cycle: to activate
or deactivate recall of the programme
which you used last when switching
on the dryer
Eco mode: to activate or deactivate
the automatic switch-o function
after programme end
Factory settings: to return to factory
settings
Live menu: remote control settings
Press and hold the Settings button
for at least 3 seconds . The display
indicates that you entered the
Settings mode.
Press the UP or DOWN key to navigate
through the settings. Conrm the
setting which you want to change by
pressing the OK key.
Press the UP or DOWN key to adjust
the setting, and afterwards press the
OK key to conrm.
Press the Settings button to exit. If
you do not press the Settings button,
the settings mode will be exited
automatically after about 10 seconds.