Instruction for Use

ManualsBrandsBauknecht ManualsDomestic AppliancesGSU 81414 A++ WS

EN -1-

Chart

TABLET

SETTING

This setting allows

to optimize the

cycle

performances

according the type

of detergent used.

Push the Tablet

button (the

indicator lights up)

if you are using the

combined

detergents in

tablet.

If you are using

powder or gel

detergent, the

Tablet indicator

on the control

panel has to be off.

DELAYED START

BUTTON

Push the button (repeatedly)

to delay the start of the

program. Adjustable from

0:30 to 24 hours. With each

press of the button, the

delay start increases by: 0:30

if selection below 4 hours,

1:00 if selection is below

12 hours, 4 hours if selection

is above 12 hours. If 24

hours reached, and the

button is pressed, the

delayed start is deactivated -

"OFF" message is shown.

Then press the START

button. The delay time can

be adjusted after Start key

press. The dishwasher will

start after the set time.

START/PAUSE/

RESUME

BUTTON

Push this button to

start the selected

program: the

indicator lights up

and goes off at the

end of the program.

Press Start button or

open the door

during washing cycle

to pause the cycle -

the Start Indicator

blinks.

To resume the cycle

push Start button

and close the door.

CANCEL/OFF

BUTTON

Push this button to

switch off the control

panel.

If pressed for 3 seconds

when a program is

running it cancels this

program. If pressed

for 3 seconds when

the dishwasher is off,

it drains the water out.

If pressed during

program and delayed

start selection it

cancels the selection

and returns to

previous cycle and

option selection.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

4000 107 33080

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

ECO PROGRAM

INDICATOR

When lit, it indicates that

standard program is active.

MULTIZONE

INDICATOR

When lit, it indicates the

wash in the upper or lower

rack only.

KEYBOARD LOCK

INDICATOR

When lit, it indicates that

keyboard lock is active.

WATER TAP CLOSED

- Alarm

Blinks when there is no inlet

water or water tap is closed.

WASH TIME DISPLAY

Indicates the cycle duration and the remaining time (h:min). With “Delayed start”

selected it indicates the time remaining until program start: “h24” if above

10 hours delay time remain and “h:mm” if below 10 hours delay time remain.

If “Fx Ey” messages appears on the display, see page 8 - chapter “What to do if...”.

DELAY INDICATOR

When lit, it indicates that delay

is active.

RINSE AID

INDICATOR

When lit (at the end of the

cycle), the rinse aid dispenser

needs to be refilled.

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir needs

to be refilled.

PROGRAM

SELECTION

BUTTON

Push “P” button

(repeatedly) until

selected

program number

is shown on the

display (P1...Px) -

see “Table of

programs” - next

page.

After 3 seconds

the cycle

remaining time is

displayed.

POWERCLEAN

Thanks to the additional power

jets this option provides a more

intensive and powerful wash in the

lower rack, in the specific area.

MULTIZONE

Allows you to choose

the washing zones.

The appliance washes

both racks by default

(indicators are not lit).

To wash only in

specific rack, press

this button

repeatedly:

KEYBOARD

LOCK

This option allows you

to lock the buttons on

the control panel.

Children will not be

able to accidentally

start the dishwasher

by pressing the

buttons on the control

panel when this

option is selected.

If you want to activate

this option hold down

the button for

3 seconds.

Repeat the same

operation to unlock

the panel.

only upper rack

indicator lit

only lower rack

indicator lit

ANTIBACTERIAL

RINSE

This function activates an

antibacterial rinse at the end of the

wash cycle, guaranteeing a further

reduction of bacteria.

Press the button to activate or

deactivate the function.

This function can be used with the

programs indicated in the table of

programs.

The dishwasher door must be

kept shut for the entire duration of

the program in order to guarantee

reduction of bacteria.

If the door is opened the indicator

lamp starts flashing.

Quick reference guide

Bauknecht is a registered trademark

Summary of content (11 pages)

PAGE 1
Chart Quick reference guide BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. ECO PROGRAM INDICATOR WASH TIME DISPLAY When lit, it indicates that standard program is active. Indicates the cycle duration and the remaining time (h:min).
PAGE 2
Chart Quick reference guide Table of programs Available options Loading instructions 40-70°C Delay Multizone PowerClean® Antibacterial Rinse Use for normal soiled dishes with dried-on food. Senses the level of soiling on the dishes and adjusts the program accordingly. When the sensor is detecting the soil level an animation appears in the display and the cycle duration is updated. The PowerClean® option is activated automatically with this program.
PAGE 3
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set before the first wash or if water hardness has been changed Water hardness level is factory set for medium-hard water (level 4). - Press and hold together Program and buttons for minimum 3 seconds. The current water hardness setting will be visible on the display. Press the Program button to increase setting.
PAGE 4
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator 2 Visual indicator If required, open the cover B (press the dedicated button). Check the rinse aid indicator to check the level into the dispenser. The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B.
PAGE 5
How to load the racks UPPER RACK - depending on the model 4 A - Adjustable flaps (2 or 4): In horizontal position for cups / long utensils / steemed glasses. A CLOSED A -- CLOSED AA- -OPEN OPEN B - Cutlery basket: Can be placed in the upper rack when the “Half load/Multizone” option is selected. The Grid (F) should be removed.
PAGE 6
How to load the racks UPPER RACK - depending on the model 4 E - Cutlery basket F - Grid: Helps to keep the cutlery separate for better washing results. G - Vertical plate holders: They can be folded down to load pots. H - Lateral support with foldable flaps (if available): Shelves can be used to hold long tools or cups onto. THE LATERAL SUPPORT CAN BE REMOVED: Pull the support to the front of the basket and lift to remove it.
PAGE 7
Select program 6 Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. For hygienic reasons it is recommended to run a high-temperature cycle (e.g. Intensive 65) at least once per month.
PAGE 8
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes... Solutions... salt indicator is lit - Salt reservoir is empty. (After refill the salt indicator may remain lit at the end of the several - Refill reservoir with salt (for more information - see page 3).
PAGE 9
What to do if... Crockery and cutlery... ...are not perfectly clean/have food residues ...have deposits: regeneration salt residue ...are not dry Possible causes... Solutions... - Too little space between dishes (incorrect arrangement of the concave items in the rack). - Arrange crockery so that items do not touch each other. Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack. - Too little detergent; detergent too old or incorrectly stored.
PAGE 10
What to do if... Crockery and cutlery... Possible causes... Solutions... ...have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening. Programs with higher wash temperatures should be used. ...opaque glasses, etc. - Dishes unsuitable for washing in dishwashers (porcelain), ...
PAGE 11
Precautions and general recommendations 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3. Before using the dishwasher for the first time - The appliance is designed to operate with a minimum ambient temperature of 5°C.