Instruction for Use

GB5
Before calling the After-Sales Service:
1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide".
2. Switch the appliance off and back on again it to see if the fault persists.
If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service.
Always specify:
• A brief description of the fault;
• The exact type and model of the appliance;
• The service number (number after the word "Service" on the rating plate), located on the inside of the appliance. The service number is also indicated on
the guarantee booklet;
• Your full address;
• Your telephone number.
If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out
correctly).
AFTER-SALES SERVICE
- Never use steam cleaning equipment.
- Disconnect the appliance from the power supply.
IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean
immediately with a damp cloth.
• Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth.
IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the enamel surface.
• Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions.
IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals.
WARNING
CLEANING
Note: the elements marked with the symbol “(*)” are optional accessories supplied only with some models or elements to purchase, not supplied.
Extraction version installation (A): Fumes are extracted and expelled to the outside through an exhaust duct fixed to the upper circular flange A1 (bayonet
coupling + screw fastening), remove the prescored metal panel and fit the duct connector.
Filter version installation (F): If fumes and steam cannot be discharged to the outside, the hood can be used in filter version by fitting a carbon filter/s (*);
fumes and steam are recycled through the front grille located above the control panel (do not remove the pre-scored metal panels!).
Check the position of the extraction/filter selector (inside the hood) G.
Wall fixing - Place the hood against the wall (or use the template H, if provided) and mark the holes (3 or 4 Ø 8 mm holes) with a pencil, drill, insert the wall
plugs J in the holes and 2 screws K in the top holes, remove the grille and hook the hood on the 2 screws, then insert the third (and fourth) screw/s L from inside
and tighten all of them.
Fixing to wall unit - Position the hood (or use the template H, if provided) and, using a pencil, mark the 4 Ø 6 mm through holes to be made on the bottom of
the wall unit.
Fix the hood with 4 screws M from inside the wall unit.
INSTALLATION - FITTING INSTRUCTIONS