GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.bauknecht.eu. YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. Use the correct length for the screws which are identified in the Installation Guide. In case of doubt, consult an authorised service assistance centre or similar qualified person.
AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". 2. Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service.
DESCRIPTION AND USE OF THE HOOD Control panel Light: move the switch to the right or press the next button to switch on. Extraction speed: Move the switch to the right or press the next button to increase extraction speed. Note: You should open the visor N every time you switch on the hood in order to use it correctly. Grease filter - can be one of the following types: Paper filter: to be replaced once a month or, if the top part is coloured, when the colour shows through the holes in the grille.
min min min * only present on some models
09/2016 400011025474 GB Bauknecht® Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2015. All rights reserved - docs.bauknecht.
