Quick Start Guide

2
ACCESSORIES
Download the Use and Care Guide from docs.bauknecht.eu for
more information
WIRE SHELF DRIP TRAY BAKING TRAY SLIDING RUNNERS
The number and type of accessories may vary depending on which model is purchased. Other accessories can be
purchased separately from the After-sales Service.
INSERTING THE WIRE SHELF AND OTHER
ACCESSORIES
Insert the wire shelf horizontally by sliding it across the
shelf guides, making sure that the side with the raised
edge is facing upwards.
Other accessories, such as the drip tray and the baking
tray, are inserted horizontally in the same way as the
wire shelf.
REMOVING AND REFITTING THE SHELF GUIDES
. To remove the shelf guides, remove the xing
screws (if present) on both sides with the aid of a coin
or a tool. Then, lift the guide and remove the lower
components from their seating: the shelf guides can
now be removed.
. To ret the shelf guides, rst t them back into their
upper seating. Keeping them held up, slide them
into the cooking compartment, then lower them into
position in the lower seating. Ret the xing screws.
FITTING THE SLIDING RUNNERS
(IF PRESENT)
Please note: The sliding runners can be already mounted on
the shelf guides: to remove them, pull outward, releasing rst
the lower clip.
Remove the shelf guides from the oven and remove the
protective plastic from the sliding runners.
Fasten the upper clip of the runner to the shelf guide
and slide it along as far as it
will go. Lower the other clip
into position.
To secure the guide in place, rmly press the lower
portion of the clip rmly
against the shelf guide.
Make sure that the runners
can move freely. Repeat
these steps on the other
shelf guide on the same
level.
Please note: The sliding runners
can be tted on any level.
WWW