Quick Start Guide

REMOVING AND REFITTING THE DOOR

1. To remove the door, open it fully and lower the

catches until they are in the unlock position.

2. Close the door as much as you can. Take a rm hold

of the door with both hands – do not hold it by the

handle. Simply remove the door by continuing to close

it while pulling it upwards at the same time until it

is released from its seating. Put the door to one side,

resting it on a soft surface.

~15°

3. To ret the door, move it towards the oven, aligning

the hooks of the hinges with their seating and securing

the upper part onto its seating.

4. Lower the door and then open it fully. Lower the

catches into their original position: Make sure that you

lower them down completely.

Apply gentle pressure to check that the catches are in

the correct position.

“CLICK”

5. Try closing the door and check to make sure that it

lines up with the control panel. If it does not, repeat the

steps above: The door could become damaged if it does

not work properly.