Manual

EMPIREPAINTBALL.COM
3
• Keep your finger out of the trigger guard and away from the trigger;
point the muzzle of the marker in a safe direction at all times. Keep the
marker turned OFF until ready to operate. The TM-7 uses an ON/OFF
switch and a selector switch for its safety devices.
• Always keep your TM-7 pointed in a safe direction. Always use a barrel
plug or barrel blocking device. Always use ASTM approved paintball
specific eye protection in any areas where paintball markers may be dis-
charged. Remember that the ultimate safety device is you, the operator.
Barrel Installation
Make sure marker is degassed, hopper removed, no paintballs in the feed
elbow or breech and the TM-7 is turned off.
• While pointing marker in a safe direction, place the threaded end of the
barrel into the front opening of the marker body.
• Turn the barrel clockwise until it stops (do not over tighten).
• Install a barrel blocking device. This can be a barrel plug or other such
device that prevents the accidental discharge of a paintball.
Feedneck Installation
Seat the feed elbow onto
the narrow section of the
top rail, about 2 inches
back from the front of the
shell. Then push and hold
in the latch button while
sliding the feed elbow
toward the rear of the marker. Just before the feed elbow covers the feed
hole in the right side of the marker, release the latch button and continue
sliding the feed elbow until the latch locks into the rail slot. When done
correctly, the feed elbow will now be unable to slide forward or backward
without holding in the latch button, and the feed hole in the right side shell
will not be visible from the sides of the feed elbow.
Switching On your TM-7
To switch the TM-7 ON, set the Selector
Switch to the Safety position. Locate
the Power Button on the left side of the
marker. Push and hold the button for
2 seconds and the LED light will turn
Green and then to Red. Release button
and the LED will remain RED.
The TM-7 will now be ON and in the Safety Position. To make the TM-7
Live, move the Selector Switch to the desired Firing Mode.
Switching OFF your TM-7
Move the Selector Switch to the Safety Position, push and hold the Power
Button for 2 seconds and the LED will turn from Red to Green. Release
button and the TM-7 will switch OFF.
Selector Switch
The TM-7 comes equipped with a 4 position Selector switch. The TM-7 comes
factory set in the recreational firing mode setting. Simply move the selector
from Position (0) Safety, to Positions (1-3) to change to a Firing Mode.
Selector Positions
0 = Safety -------------------------
1 = Semi Auto ----------------
2 = PSP Burst ----------------
3 = NXL Full Auto ------------------
Automatic OFF feature
The TM-7 also has an “Automatic OFF” feature. If you accidentally leave
your TM-7 powered up, it will shut itself OFF after approximately 1 hour
of inactivity.