Manual

EMPIREPAINTBALL.COM
13
Re-Installation of Main Spring, Bolt and Bolt Guide Assembly
• Slide the Main Spring onto Bolt, and then the Bolt onto Bolt Guide, so
it is one assembly. You will notice, one end of the spring is smaller and
will lock onto the bolt.
• Insert Bolt Assembly back into the body.
• Line up the alignment hole on the guide with the alignment pin on the
body and slide the bolt assembly fully forward to the body.
• Holding the bolt assem-
bly tight into the back
of the body with one
hand, reinstall the Bolt
Guide retention screw
and tighten using the 1/8” Allen key.
Circuit Board Removal
The Circuit Board should only need to be removed to clean the break
beam eyes.
• Remove the Body Assembly from the shell.
• Using a 5/64” Allen key, remove the two Circuit Board screws and
gently remove the Circuit Board.
Wiring Harness Removal
Note: The wiring harness should only need to
be removed if you are washing the right shell
of the TM-7.
• Carefully pull the 2 battery spring tabs out
of the right side shell, using needle nose pli-
ers. Be careful not to break the wires from
the battery tabs.
• Then lift the wiring harness guide OFF, and remove harness.
Re-Installation of Wiring Harness
Make sure the wire harness is routed
through the circuit board and along
the body above the circuit board as
shown and not through the trigger area.
Failure to route the wires properly will
result in destruction of the wires during
re-installation of the shell, and can result
in an electrical fire when the battery is installed. Destruction of the wire
harness is not covered under warranty.
Regulator Hex Adjustment
The Regulator has 2 Hex spacers which hold the shell together and the grips
on. If they need adjusting, simply insert an Allen key and push it thru the shell
and hex. This will align the hex spacers and the screw will go in easily.
15. Storage and Transportation
IMPORTANT: Never carry your TM-7 uncased when not on a playing
field. The non-playing public and law enforcement personnel may not be
able to distinguish between a paintball marker and firearm. For your own
safety and to protect the image of the sport, always carry your TM-7 in a
suitable marker case or in the box in which it was shipped.
• Your TM-7 must be clear of all paint and propellant when not being
used.
• Make sure the TM-7 marker is OFF. Push the Power button and hold
for 2 seconds until the LED light changes from Red to Green.
• Put the barrel blocking device in its place. Make sure the marker is
clean.
• Store your TM-7 in a clean, cool, dry place.