Manual

9
5. MARKER ADJUSTMENTS (Cont’d)
• The (1) first set screw adjusts forward
movement, and forward stop point.
• The (2) second set screw adjusts the rear
movement range, and rear stop point.
• The (3) third set screw adjusts the
Trigger activation point. For best results,
the activation point should be set right in
the middle of the total Trigger movement
from front to back.
Notes:
• If any of the set screws are over adjusted
in any direction the D*Fender may
not fire.
• If the Trigger travel is adjusted too short, the D*Fender may fire on its
own, repeatedly and/or uncontrollably.
APEX
2
Barrel Adjustment:
Setting the Apex
2
Barrel Ramp
1. Start with the Ramp in the OFF position
(fully toward the back of barrel, Fig 5.4).
2. Follow all safety and paintball loading
instruction for safe use.
3. Go to your fields shooting range or other
approved firing area.
4. While firing, gradually adjust the Ramp forward until you see the balls start to
change their trajectory. The further you move the Ramp forward; the balls will have
higher degree of curve.
Adjusting Direction of Shots
1. Adjust the shot direction of the APEX
2
by turning the tip.
2. Be careful not to unscrew the barrel when turning the tip in a counter-clockwise direction.
3. Rotating the tip to the right will give your shot a right hook curve.
4. Rotating it left will give you a left hook.
5. Rotating it 180 degrees will give you a drop shot.
6. The standard position will give you a longer shot with the ramp engaged.
Note: It will be necessary to adjust the Ramp setting on the APEX
2
barrel to the paint you are
using. Different brands/types of paintballs will slightly vary in size and will affect the amount
of curve you get. Too much ramping may cause paintballs to break.
6. ELECTRONIC SETTINGS
The board allows users to change the following settings: Firing Mode, Max ROF, Dwell,
De-Bounce, Ball in Place, Ramp Start, Ramp Sustain and also to recalibrate
the Selector Switch.
Activating Settings Mode:
• Marker must be powered Off before you can adjust any settings.
• To activate the Settings Mode, press and hold the Trigger while also pressing and holding
the Power Button. The LED will cycle through an array of colors and stop on Red to
indicate Settings Mode is active once the Trigger and Power Button are released.
• To exit Settings Mode press and hold Power Button until the LED turns off.
5.4
5.3