Manual

19
10. TROUBLESHOOTING (Cont’d)
Velocity Is Inconsistent
• Assure fresh batteries are being used. Lubricate and/or replace the poppet O-ring.
Set pressure near 200psi. Replace small bolt guide O-rings.
ROF / Feeding Issues:
ROF is Very Slow, Around 8 BPS
• Your breech sensor (eyes) may be dirty or malfunctioning. Clean the eyes and breech of
the marker. Tapping the power button can toggle the eyes off if they cannot be cleaned
immediately. Check if there is paint in the feed ramp or loader area. Replace the battery if
cleaning the eyes doesn’t work.
ROF is Slightly Slow
• Bolt may not be cycling fast enough. Remove bolt system and clean and lubricate bolt and
bolt guide.
Loader is Spinning Very Fast and Stopping Quickly
• The batteries may be low. Try changing the batteries. If not the loader gear sensor may be
dirty or disconnected. Split the body shells in half to check the connection and sensor.
Loader is Not Feeding Balls Fast Enough
• The batteries may be low, change the batteries.
The Marker Sometimes Fires 2 Balls at Once / Double Feeding
• Your ball detents may be damaged or missing. Check them for damage and replace
if necessary.
Other Issues:
The Marker Has Inefficient Gas Use
• The paint barrel match may be incorrect. Check that a suitable bore insert is installed.
The check valve may be missing. Remove the air transfer plate to inspect.
The Marker is Breaking Paint in the Breech
• The ball detents may be damaged or missing. Check for the ball detents and replace if
necessary. The rubber bolt tip may be damage or missing, remove the firing system
to check. The check valve may be missing. Remove the air transfer plate to inspect.