Manual

11
6. ELECTRONIC SETTINGS (Cont’d)
Select Fire Mode – (DEFAULT) Select Fire mode allows the user to change the firing mode by
using the Selector Switch on the left side of the marker. In the Safe position the marker will
not fire. In position 1 the marker will fire in Semi Auto mode. When in position 2 the marker
will fire in Burst mode. When in position 3 the marker will fire in Full Auto. Below is the LED
color corresponding to the firing mode when Select Fire mode is active.
Max Rate-Of-Fire (ROF, Solid Green): Default 15 blinks = 15bps
This setting controls the maximum rate of fire the marker is allowed to fire; setting can be
varied from 8 to 20 balls per second (bps) in .5bps intervals.
Note: The maximum Rate of Fire is capped at 15.0 BPS for all modes other than Semi-Auto
per ASTM requirements. Semi-Auto has a maximum ROF of 20 BPS.
Dwell Setting (Solid Blue): Default 11 blinks = 8ms
This setting controls the amount of time the solenoid valve is left open. A setting too high will
waste excess gas and affect efficiency. A setting too low will prevent marker from operating
properly. It is not recommended to change this setting unless you are an experienced user.
Minimum dwell time is 3.0ms and is increased in .5ms increments up to 10ms. The Dwell is
adjustable from 1-15 blinks.
Dwell Equation: Dwell in ms = .5 x Blinks + 2.5ms
POSITION
3
2
1
Safe Green or Blue Safe
Red Semi-Auto
Amber Burst
Purple Full-Auto
LED COLOR FIRING MODE
BLINKS VALUE VALUEBLINKS
# OF BPS BPS# OF
5 13.5
6 14.0
7 14.5
4 13.0
3 12.5
2 12.0
1 11.58.0 8
8.5 9
9.0 10
9.5 11
10.0 12
10.5 13
11.0 14
BLINKS VALUE VALUEBLINKS
# OF BPS BPS# OF
19 20.0
18 19.5
17 19.0
16 18.5
15 18.015.0 21
15.5 22
16.0 23
16.5 24
17.0 25
20 17.5
BLINKS IN MS IN MSBLINKS
# OF DWELL DWELL# OF
5 9.0
6 9.5
7
8
10.0
4 8.5
3 8.0
2 7.5
1 7.03.0 9
3.5 10
4.0 11
4.5 12
5.0 13
5.5 14
6.0
6.5
15