User Manual

EMPIREPAINTBALL.COM
7
• Left hook, right hook, drop shot and long flat trajectory shots with a twist of the barrel.
• Easy to dial in targets and change the level of curve.
Setting the Apex™ Barrel Ramp
1. Start with the ramp in the OFF position (toward the back of barrel) (Fig. 8.1).
2. Follow all safety and paintball loading instruction for safe use.
3. Go to your fields shooting range or other approved area.
4. Gradually adjust the ramp forward until you see the balls start to change their
trajectory. The further you move the
Ramp forward; the balls will have higher
degree of curve.
Adjusting Direction of Shots
1. Adjust the Apex front by turning it.
2. Turning it right will give you a right
hook.
3. Turning it left will give you a left hook.
4. Rotating it 180 degrees will give you a
drop shot.
5. The standard position will give you a long shot.
Note: It will be necessary to adjust the Ramp setting on the Apex barrel to the paint you
are using. Different brands/types of paintballs will have a slightly different size. This will
affect the amount of curve you get.
9. Accessory Adjustments
Adjusting the Car-Stock (Omega
model)
Push the stock adjustment lever up and
adjust the stocks length by pulling or
pushing on the back of the stock (Fig. 9.1).
Adjusting the Delta Stock (Delta
and Delta Elite models)
Push the stock adjustment lever to the left and adjust the stocks length by pulling or
pushing on the back of the stock (Fig. 9.2).
Vertical Foregrip Adjustment (Combat and
ERC models)
1. Turn vertical foregrip retainer counter clockwise to
allow retention pin to drop. A coin may be used to
assist in turning the vertical foregrip retainer (Fig.
9.3).
2. Slide foregrip to preferred location.
3. Reverse process to tighten foregrip.
Note: that the retention pin must line up in a gap on
the picatinny rail.
Magazine Adjustment (Omega, Delta, and
Delta Elite models)
1. Remove the 2 screws (Omega Model) (Fig. 9.4)
and locking metal plate. (Metal plate applies to
Delta and Delta Elite models) (Fig. 9.5).
2. Slide the magazine assembly to new location.
3. Reinstall the plate and screws, making sure they
are going into a Picatinny notch.
4. Tighten screws.
10. Unloading Your Marker
1. Put on an eye protective device designed specifically for
paintball and make sure that anyone within range of the
Empire BT-4 Series Marker does the same.
2. Make sure the barrel blocking device is properly installed and
the marker is set to “safe” mode.
3. Loosen the loader clamping screw or release clamping arm.
4. While holding the paintball hopper in place, invert the marker
Fig. 8.1
Fig. 9.1
Fig. 9.2
Fig. 9.3
Fig. 9.4
Fig. 9.5