User Manual

EMPIREPAINTBALL.COM
3
Feed Elbow/Rip-Clip and Loader Installation
Standard Feed Elbow
1. Press and hold the retention button located on the
side of the Slide-Away™ elbow (Fig. 3.8).
2. Slide the elbow onto the front of the picatinny rail.
3. Line up the elbow with the feed hole on the right
side receiver.
4. Check that the elbow is locked in place and properly aligned.
Note: Spring-loaded retention button must line up in a gap on the picatinny rail.
Delta Feed Elbow (Fig. 3.9)
1. Loosen up the thumb nuts on the Delta elbow.
2. Clip onto the picatinny rail, left side first.
3. Make sure the feed holes are aligned.
4. Tighten up the thumb nuts.
Standard Loader
1. To install a loader check the Slide-Away™ elbow /
Delta elbow and loader to make sure they are free
from debris and obstructions.
2. Position Slide-Away™ elbow / Delta elbow onto your marker’s receiver.
3. If equipped with a clamping screw, use a 3/16" hex wrench, loosen the clamping screw
on the Slide Away™ Elbow to allow the loader to slide into the top of the elbow.
4. If equipped with a clamping arm, release the arm to allow the loader to slide into
the top of the elbow.
5. Press the loader into the opening of the Elbow until it stops.
6. Align the loader so that the lid is pointing to the rear and the loader is parallel
with the marker.
7. Clamp the loader in place by using a 3/16" hex wrench or lock the clamping arm.
Tighten the clamping screw on the Elbow until snug or close the clamping arm.
Do not over tighten the loader.
Note: It might be necessary to adjust the clamping feed elbow screw to fit your
loader. Using a 3/32" hex wrench, turn the screw clockwise to increase the clamping
force or counter-clockwise to decrease
the clamping force.
Rip Clip™
1. Loosen up the thumb nuts on the Rip
Clip™ (Figure 1).
2. Clip onto the picatinny rail, left side
first (Figure 2).
3. Make sure the feed holes are
aligned (Figure 3).
4. Tighten up the thumb nuts (Figure 4).
Rip Clip™ Loader
Insert the loader onto the Rip Clip™
as indicated. Turn the loader Counter-
clockwise until it locked firmly.
Air Cylinder Installation (all models)
Consult the place where you purchased your Empire BT-4 Series Marker, or
a recognized and competent air smith, for instruction in the safe handling of
compressed-air cylinders before purchasing or connecting one to your Empire BT-4
Series Marker.
Before Pressurizing Your Marker
1. Check to make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Double check that all screws are tightened and no parts are loose before installing
your tank.
3. Ensure you have a barrel plug, barrel sock or other specifically designed barrel-
blocking device in place.
4. Make sure there are no paintballs in the marker.
5. Set marker to “SAFE” mode.
Figure 1
Figure 3
Figure 2
Figure 4
Fig. 3.9
Fig. 3.8