User Manual

ManualsBrandsBattle Tested ManualsPaintballBT-4 Combat -All Models

EMPIREPAINTBALL.COM

Barrel Removal (all models)

Turn the barrel counter clockwise to remove it from the marker. Keep your barrel

clean for best results.

Feed Elbow and Rip Clip™ Removal

Slide-Away™ Elbow

1. Press and hold the retention button located on the name plate side of the Slide-

Away™ Elbow (Fig. 13.1).

2. Slide the Elbow toward the front of the marker and remove.

3. Reverse process to replace Slide-Away™ Elbow.

Delta Feed Elbow

1. Loosen the two thumb nuts.

2. Lift the feed elbow away from the receiver.

3. Lift off the receiver.

Rip Clip™

1. Loosen the two thumb nuts.

2. Lift the Rip Clip™ away from the receiver.

3. Lift off the receiver.

Front Foregrip Removal

1. Turn the vertical foregrip bolt counter clockwise to allow retention pin to drop. A

coin may be used to assist in turning the vertical foregrip bolt (Fig. 13.2).

2. Slide foregrip to preferred location or remove if so desired.

3. Reverse process to replace foregrip.

Sight Rail Removal (Omega Model)

Rear Notch Sight

1. Using a 1/8" Allen wrench, loosen the rear sight

retaining screw (Fig. 13.3).

2. Slide sight off the picatinny rail.

Delta Sight Rails

1. Remove the Delta Feed Elbow / Rip

Clip™ and barrel assembly.

2. Slide the small front sight rail forward

and off the receiver.

3. Loosen the 3 screws with a Phillips

screwdriver on the left side of the rear

sight rail.

4. Slide the sight rail toward the back of

the marker and remove.

Note: It may not be necessary to loosen the 3 screws on the Delta rear sight; see if

it slides off first.

Trigger Frame Removal (all models)

1. Extend the stock on all Delta and Omega models.

2. Remove the two grip retention screws from the pistol grip.

3. If the acorn shoulder nuts located in the pistol grip do not fall out after the screws

are removed, then press them out with a small hex wrench or screwdriver.

4. Lower the frame from the receiver.

Note: The frame will still attached to the receiver by the steel braided hose. It is

recommended that you do not remove the hose from the valve or the tank adapter.

Fig. 13.3

Fig. 13.1

Fig. 13.2