Product Manual

BatteryMINDer
®
Model SCC180
Rev. E-052115 Page 12 P/N VDC SCC180-MNL
BCI Installation
Turn engine and ALL accessories off. Carefully think of the best location on
or near your battery to locate your BCI so it can be easily seen and read.
Clean surface you plan to attach BCI to using an alcohol cleaning pad.
Attach the ring terminal on the RED wire of your BCI to the (+) Positive
clamp on your battery.
Attach the ring terminal on the
wire of your BCI to the (-)
Negative clamp on your battery.
TESTING BATTERY
(Engine and ALL loads must be off
for accurate readings) Remember,
only test a fully charged battery
and only after it has “rested”* for 10
hours minimum.
Press the area on the face of your
BCI in raised area marked PUSH.
If all three (3) LEDs light (RED,
YELLOW and GREEN) your battery
is “good” = fully charged = 12.8 –
13.2 volts
If only the RED and YELLOW LEDs
light your battery is “fair” = 11.8 –
12.7-volts
If only the RED LED lights your
battery is in “poor” condition (11.2
– 11.7-volts. Battery needs to be
desulfated fully before it can be further evaluated to determine if it can be
returned to “good” condition.
WHEN NO LEDs are
lit, battery can be
considered “DEAD”,
unlikely able to be
restored. AGAIN, this
can only be accurately
determined if you have