User Manual

BatteryMINDer

Aviation-Adjusted Models E12248-AA-S2, S3 & S5

Rev. C-071213-1 Page 9 P/N VDCE12248-AA-Sx-MNL

SIMPLIFIED OPERATING INSTRUCTIONS

Read and thoroughly understand ALL SAFETY Instructions, pages

3 - 7 including Preparing to Charge, DC Connection Precautions,

Unit Location and Qualifying Your Battery BEFORE proceeding

further.

1. Attach Battery Clips (7) (supplied), to output cordset of charger (4).

2. Attach output to battery terminals:

RED band = Positive +

BLACK band = Negative -.

3. Ambient Temperature Sensor, ATS-1 (8), comes already installed on

the Temperature Sensor input connector (3). Do not detach. The

Ambient Temperature Sensor (ATS-1) is mandatory when used

with all Aviation batteries.

4. Plug AC power cord (5) into a 220 - 240 Vac electrical outlet.

5. Observe Reversed Polarity GREEN/RED LED indicator (1a):

If lit RED, reverse battery connector attachments on battery.

6. Observe Charging - Maintenance/Desulfating GREEN LED

indicator (1c):

Solid = charging

Blinking = maintaining battery(s).

Charger will automatically start within 30 seconds or less.

7. Observe Battery Connected - Error LED Indicator (1a):

Must be lit GREEN

Be sure Maintaining - Desulfating LED (1c)

is BLINKING before leaving

unit for an extended period of time. Otherwise, press & hold the

Maintenance button (2) for 3 seconds.

IF IN DOUBT REGARDING ANY OF THE ABOVE, REFER TO Detailed

Operating Instructions, page 12.

See full instructions if not lit GREEN.