Owner's manual

Rev. I-100511 Page 23 P/N VDC28252-AA-Series-MNL
BatteryMINDer
®
Model 28252-AA-Series
TROUBLE SHOOTING
Problems Indication Possible Causes Suggested Solution Unit does not work Indicator LEDs are not on No AC power Check AC connections and make sure Power switch is ON Unit has no DC output
Error LED is ON. LCD displays E01
Output is short circuited Output polarity connection to battery is reversed
Check DC connection between unit and battery and make sure they are not short-circuiting Check clips / ring terminals to be sure polarity is correct
No Charging Current Error LED is Flashing and
LCD displays E04
Battery is severely sulfated Battery has a damaged cell Battery aged
Check the Battery condition, age, etc. If battery cannot be desulfated, it must be replaced
Stop charging during charging progress
LCD displays E05 or E06 Battery charger internal over heat
protection is activated-on, shutting down charging functions Fan faulty
Move battery & Unit to cooler environment Check the fan on unit
Long charging time, FLOAT LED does not come on
Fault LED is Flashing LCD displays E02, E03 or E04
Battery capacity is too large or bat- tery is in very poor condition 6 hours soft start timer reached 15 hours bulk charge timer reached 12 hours absorption timer reached
Check charging rate, battery type and condition Battery cannot be charged and must be replaced
LCD displays Normal charge, but Error LED continuously Flashes
Error LED Flash, LCD meter displays normally
Sensor connections are faulty or loose
Check Sensor connections Ring terminal must be firmly fastened to the battery poles
Abnormal LED indication
ALL LED’s continuously or intermittently Flash
Poor connections from Unit to Battery
Check for loose battery terminal connections Check output lead clips. May be loose / damaged