Manual

Rev. F-103007 P/N VDC24041AA-S1-MNL
BatteryMINDer
®
Model 24041-AA-S1
Page 7
Do not connect clip to carburetor, fuel lines,
or sheet metal body parts. Connect to heavy
gauge metal part of frame or engine.
h. When disconnecting charger, disconnect char-
ger from AC outlet, then remove clips from vehicle
chassis, and battery posts.
Operating instructions for charge information.
FOLLOW THESE STEPS WHEN BATTERY IS
OUTSIDE OF AIRCRAFT OR EQUIPMENT.
A SPARK NEAR THE BATTERY MAY CAUSE
BATTERY EXPLOSION. TO REDUCE RISK OF
A SPARK NEAR BATTERY:
a. Check polarity of battery posts. POSITIVE
(POS,P,+) usually has a large diameter than
NEGATIVE (NEG, N, -) battery post.
b. Connect (RED) charger clip to (POS+) post of
battery.
c. Position yourself and free end of cable as
far away from battery as possible, then connect
NEGATIVE (BLACK) charger clip to free end of
cable.
d. Do not face battery when making final con-
nections.
e. When disconnecting charger, always do so
in reverse sequence of connecting procedure
and break first connection while as far away from
battery as practical. Do not attempt to per-
manently install any charger not specifically
designed for permanent installation, espe-
cially in a wet / marine environment