AGS — ASS TWOSOME housemaster Bluetooth Pairing a. Pairing your device for the first time: First step Please make sure the headset is fully charged before starting pairing. *The headphones and charging case are packaged separately. Second step Remove the right earphone from the charging case and it will automatically enter pairing mode. Startup sound, Power On indicator flashes quickly.
AGS — ASS TWOSOME housemaster Bluetooth Pairing « Setter Bluetooth §@ > Third step Go to the Bluetooth menu in your device. Select "A&S Batman™ Make a connection The fourth step Remove the left earphone from the charging case, It will automatically connect the right earphone. b. Second pairing: ‘When removing the headset from the charging case, The wireless connection is established automatically. ¢. When put in the charging case, the headset will automatically turn off and start charging.
(B)rss — ALS TORTOISE verses TWS Operation b. Press and held for 5 seconds ©.
A&S TWS02SE User Manual A&S Specifications Speaker Size: pommy Speaker Impedance: 168) Frequency Range: 20Hz-10kHz Sensitivity: 99 + 3dB Bluetooth Version: 5.0 Bluetooth Technology: 2.4G Bluetooth Protocol: HSP, HFP, AVDP, RCPT Bluetooth Transmission Distance: 10-15M Charging Box Charging Method: (D Type-C © Wireless Charging Charging Box Charging Voltage: DC ~ 6V Charging Case Charging Current: 0.44 Charging Case Standby Power Consumption: 75uA Charging Box Output Current: 0.5A Charging Tire: 1.
A&S A&S TWS02SE User Manual Precautions Avoid Hearing Damage WARNING: permanent hearing loss may occur if headphones are used at high volume. Set the volume lo a safe level. You can adapt over time to 8 higher volume of sound that may sound normal but can be damaging to your hearing, If you experience ringing in your ears of muffled speech, stop listening and have your hearing checked. The louder the volume, the less time is required before your hearing could be affected.
A&S A&S TWS02SE User Manual FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
