SDS
Tub Refinishing Inc., DBA Munro Products Page 5 of 9
0064742-95-6
Petroleum naphtha
NIOSH
No Established Limit
Carcinogen Data
CAS No.
Ingredient
Source
Value
0000123-86-4
BUTYL ACETATE
OSHA
Select Carcinogen: No
NTP
Known: No; Suspected: No
IARC
Group 1: No; Group 2a: No; Group 2b: No; Group 3: No;
Group 4: No;
0000822-06-0
Hexamethylene
diisocyanate
OSHA
Select Carcinogen: No
NTP
Known: No; Suspected: No
IARC
Group 1: No; Group 2a: No; Group 2b: No; Group 3: No;
Group 4: No;
0028182-81-2
Hexamethylene
diisocyanate
homopolymer
OSHA
Select Carcinogen: No
NTP
Known: No; Suspected: No
IARC
Group 1: No; Group 2a: No; Group 2b: No; Group 3: No;
Group 4: No;
0064742-95-6
Petroleum naphtha
OSHA
Select Carcinogen: No
NTP
Known: No; Suspected: No
IARC
Group 1: No; Group 2a: No; Group 2b: No; Group 3: No;
Group 4: No;
8.2. Exposure Controls
Respiratory
Select equipment to provide protection from the ingredients listed in Section 3 of
this document. Ensure fresh air entry during application and drying. If you
experience eye watering, headache or dizziness or if air monitoring demonstrates
dust, vapor, or mist levels are above applicable limits, wear an appropriate, properly
fitted respirator (NIOSH approved) during and after application. Follow respirator
manufacturer's directions for respirator use. FOR USERS OF 3M RESPIRATORY
PROTECTION ONLY: For information and assistance on 3M occupational health
and safety products, call OH&ESD Technical Service toll free in U.S.A. 1-800-243-
4630, in Canada call 1-800-267-4414. Please do not contact these numbers
regarding other manufacturer's respiratory protection products. 3M does not endorse
the accuracy of the information contained in this Material Safety Data Sheet.
INDIVIDUALS WITH LUNG OR BREATHING PROBLEMS OR PRIOR
REACTION TO ISOCYANATES
MUST NOT BE EXPOSED TO VAPOR OR SPRAY MIST. Do not breathe vapor
or spray mist. Wear an appropriate, properly fitted respirator (NIOSH approved)
during and after application unless air monitoring demonstrates vapor/mist levels
are below applicable limits. A supplied air respirator (either positive pressure or
continous flow type) is required. Follow manufacturer's directions for respirator use
and observe requirements specified in 29 CFR 1910.134.
Eyes
Avoid contact with eyes. Protective equipment should be selected to provide
protection from exposure to the chemicals listed in Section 3 of this document.
Depending on the site-specific conditions of use, safety glasses, chemical goggles,
and/or head and face protection may be required to prevent contact. The equipment
must be thoroughly cleaned, or discarded after each use.
Skin
Protective equipment should be selected to provide protection from exposure to the
chemicals listed in Section 3 of this document. Depending on the site-specific
conditions of use, protective gloves, apron, boots, head and face protection may be
required to prevent contact. The equipment must be thoroughly cleaned, or
discarded after each use.
Engineering Controls
Depending on the site-specific conditions of use, provide adequate ventilation.
Other Work Practices
Emergency eye wash fountains and safety showers should be available in the
immediate vicinity of any potential exposure. Use good personal hygiene practices.
Wash hands before eating, drinking, using toilet facilities, etc. Promptly remove