SDS

Tub Refinishing Inc., DBA Munro Products Page 5 of 9
TWA: 435 mg/m³ 8 hours.
ACGIH TLV (United States, 4/2014).
TWA: 20 ppm 8 hours.
Ethylbenzene
NIOSH REL (United States, 10/2013).
TWA: 100 ppm 10 hours.
TWA: 435 mg/m³ 10 hours.
STEL: 125 ppm 15 minutes.
STEL: 545 mg/m³ 15 minutes.
OSHA PEL (United States, 2/2013).
TWA: 100 ppm 8 hours.
TWA: 435 mg/m³ 8 hours.
OSHA PEL Z2 (United States, 2/2013).
TWA: 200 ppm 8 hours.
CEIL: 300 ppm
AMP: 500 ppm 10 minutes.
Toluene
NIOSH REL (United States, 10/2013).
TWA: 100 ppm 10 hours.
TWA: 375 mg/m³ 10 hours.
STEL: 150 ppm 15 minutes.
STEL: 560 mg/m³ 15 minutes.
ACGIH TLV (United States, 4/2014).
TWA: 20 ppm 8 hours.
8.2 Appropriate
engineering controls
Use only with adequate ventilation. Use process enclosures, local exhaust ventilation
or other engineering controls to keep worker exposure to airborne contaminants
below any recommended or statutory limits. The engineering controls also need to
keep gas, vapor or dust concentrations below any lower explosive limits. Use
explosion-proof ventilation equipment.
8.3 Environmental
exposure controls
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
8.4 Individual protection measures
Hygiene measures
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Eye/face protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles.
Hand protection
Chemical-resistant, impervious gloves complying with an approved standard should
be worn at all times when handling chemical products if a risk assessment indicates
this is necessary. Considering the parameters specified by the glove manufacturer,
check during use that the gloves are still retaining their protective properties. It should
be noted that the time to breakthrough for any glove material may be different for
different glove manufacturers. In the case of mixtures, consisting of several
substances, the protection time of the gloves cannot be accurately estimated.
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product. When there is a risk of ignition from static electricity, wear
anti- static protective clothing. For the greatest protection from static discharges,
clothing should include anti-static overalls, boots and gloves.
Other skin protection
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.