Operation Manual

4. To unscrew, setup a counter clockwise
rotating direction. Insert the screw bit into
the slot in the head of the screw. Hold the
screw-bit straight to the head of the
screw to avoid damaging the screw or
the screw head. Use a constant pressure
when pressing the screw bit against the
screw while removing the screw.
5. After screwing, always put the ash cell
screwdriver into the charger. This way it
will be ready for use all the time.
Note:
The rotating direction button can only be
pressed, while the ON/OFF trigger is
released.
LIGHT ATTACHMENT
1. R emove the screwdriver from the charger.
2. Put the light attachment (9) from below
on the grip of the ash cell screwdriver.
Make sure is audibly snaps in.
3. Press the ON/OFF switch (12) at the light
attachment to switch on the LED torch
(11).
4. Press the ON/OFF switch (12) again to
switch off the LED torch and to switch on
the LED work light (10).
5. Press the ON/OFF switch (12) a third
time to switch off both LED lights.
6. Pull off the light attachment straight from
the grip of the screwdriver in order to
remove it.
Note:
The ash cell screwdriver can only be
charged when the light attachment has been
removed.
CLEANING AND STORING
• Unplug the charger before cleaning it.
• Use only a dry or lightly moist cloth to
clean the unit. Do not use aggressive
chemicals as benzene or thinner, which
may dissolve plastic parts, or abrasives.
• Store the unit at a dry location that is
protected from dust, dirt and extreme
temperatures. Store it out of reach of
children.
TECHNICAL DATA
Charger
Rated Input Voltage 230-240 VAC
Rated Output Voltage 4.6 VDC
Rated Power Input 40 W
Rated Power Output 2.4 A
Charging Time ca. 60 s
Protection Class II
Weight 592 g
Dimensions (Approx.) 54 x 71 x 77 mm
Flash Cell Screwdriver
Input 4.6 VDC
Conductor 2.3 VDC, 300F
(2 pcs)
Max.
Torque 2.5 Nm
No Load Speed n
0
200 min
-1
Sound Pressure Level L
pA
=58.7 dB(A)
Uncertainty K
pA
=3 dB(A)
Sound Power Level L
WA
=69.7 dB(A)
Uncertainty K
WA
=3 dB(A)
Vibrations a
h
HD=0.295 m/s
2
Uncertainty K=1.5 m/s
2
Weight 366 g
Dimensions (Approx.) 53 x 185 x 145 mm
Light Attachment
LEDs 5x /
1x LED white
Weight 62 g
Dimensions (Approx.) 54 x 71 x 77 mm
The following information:
• that the declared vibration total value has
been measured in accordance with a
standard test method and may be used for
comparing one tool with another;
• that the declared vibration total value may
also be used in a preliminary assessment
of exposure.
16
TM
7061166 Ma # 1201-09.indd 16 09-01-12 12:29