User manual

until the remote tunes in and the caddy starts moving. Some models also have a green tuning
button on the controller box located underneath the battery tray. To synchronize push the green
button on the control box (either accessible through a hole underneath the battery tray or by
removing the control box lid in the battery tray) while simultaneously pushing either the
forward or reverse button on the new remote transmitter for ca. 10-20 sec. If the caddy does not
start moving at once, release and press the green button again. Please make sure that the caddy
is powered on during this procedure. We recommend taking the wheels off or jacking up the
caddy during resynchronization to prevent the caddy from getting away.
The manual control function works, but the remote control does not?
Bat-Caddy: Please confirm that the rheostat speed knob is in Off or Stop position. Also
check the batteries in your remote control handset. If it still does not work open up the
remote control and check the connections.
The caddy does not respond well to the remote control handset?
Bat-Caddy: Please check the fit and condition of the handset batteries. Make sure you
don’t exceed the range distance limit.
The trolley stops by itself sometimes?
Bat-Caddy: Please check the battery charge level. Also the controller box has a
shut-down function, if the battery is too low or the controller is overheating or the
caddy does not receive a signal for 30-40 seconds.
Whom do I contact for service, parts and technical support?
Bat-Caddy: Please contact our Bat-Caddy Service Center at 1-877-815-0809 or
1-888-214-6033 or send an e-mail to [e-mail]
Bat-Caddy® is a registered trademark of SpaCom LLC
Copyright - All Rights Reserved Bat-Caddy
Page 20 of 20