User manual

hold the Forward or Reverse arrow button on the remote control until the
indicator light flashes and simultaneously press the green button on the
controller box and hold for ca. 6-10 seconds, repeating the process until the
remote tunes in. Your caddy should now be “tuned” to the remote control.
NOTE: It is recommended to remove the rear wheels or jack up the caddy
before the synchronization process to prevent it from getting away.
3.3.3. Tracking Adjustment:
Tracking behavior of all electric caddies is strongly dependent on equal weight
distribution and slope. Test your caddy’s tracking by operating it on an even
surface without the bag. If changes are necessary you can adjust the tracking of
your caddy by loosening the front wheel axle and the adjustment bar on the right
side of the front wheel and shifting the axle accordingly. After adjustment fasten
screws in reverse order.
3.3.4. Installation of Seat (Optional)
Attach and fasten holding bar to pre-drilled holes in frame using the locking pin.
Some models have a preinstalled holding bar.
Page 10 of 20