User manual

Installation of Seat
Attach seat stand to seat bottom using the four small screws.
Attention: Attach in such manner that the seat is parallel to the driving direction of the caddy,
with the opening facing the outside when you slide it into the holding bar.
Slide seat stand into holding bar as shown. Due to the spring mechanism, the seat should reach the
ground when pushed down, so the weight rests solely on the ground.
Note: DO NOT attempt to sit on the seat while trying to move the caddy, or frame damage might
occur!
General Instructions
- In order to turn the caddy on push the On/Off switch The LEDs should light up.
- While holding on to the handle, start dialing the speed control with your index finger slowly
forward, or clockwise. The caddy will start moving forward. Adjust the speed seamlessly to the
desired pace. Reduce speed by dialing backwards.
- To stop or slow the caddy down, either dial the speed control knob backwards or use the cruise
control or On/Off button as described previously.