User manual

11
Installation of Seat
Attach seat stand to seat bottom using the four small screws.
Attention: Attach in such manner that the seat is parallel to the driving direction of the
caddy, with the opening facing the outside when you slide it into the holding bar.
Slide seat stand into holding bar as shown. Due to the spring mechanism, the seat
should reach the ground when pushed down, so the weight rests solely on the ground.
Note: DO NOT attempt to sit on the seat while trying to move the caddy, or frame
damage might occur!
Test caddy power supply by turning On/Off switch to On position (“I”) (Off is “0”). All
control lights (red, yellow, green) should come on and the caddy should be operable by
both the manual control on the handle and the remote controls. Note: Familiarize
yourself with the handle and remote control functions (X3R only) BEFORE you start
operating the caddy.