User manual

10
When your press 20M, the trolley will run 20 Meters/Yards and stop by itself.
When your press 30M, the trolley will run 30 Meters/Yards and stop by itself.
Rheostat Control: Speed can be seamlessly controlled manually via the round rheostat control
on the right side of the handle. Dial clockwise to get the caddy in motion and increase speed to
the desired walking speed. Dial counterclockwise to decrease speed and stop the caddy.
Cruise Control and Brake/Stop Function; to stop the caddy press the Cruise
Control/Stop button. Once you are ready to go again, press the button shortly, and the cart will
remember its last setting before you stopped and travel at the same speed automatically. You
can now change the speed again with the rheostat speed knob. NOTE: this button does not
start the caddy without it having been in motion before. It functions more like a cruise control
mechanism. To initially bring the caddy into motion please always use the rheostat speed
control.
Additional Functions
Freewheeling Mode; the caddy can be easily operated without power. In order to
activate the freewheeling mode, turn main power Off. The caddy now can be pushed
manually without resistance. (The freewheeling mode on some older models can also be
activated by pulling out both rear wheels by 1/2 inch (1cm) and relocking them back
into the second axle groove. Some models are equipped with both options.)
Tracking Adjustment; tracking behavior of all electric caddies is strongly dependent on
equal weight distribution and slope. Test your caddy’s tracking behavior by operating it
on an even surface without the bag. If changes are necessary, you can adjust the tracking
of your caddy by loosening the front wheel axle and the adjustment bar on the right side
of the front wheel and shifting the axle accordingly. After adjustment, fasten screws in
reverse order. Note: Don’t over tighten the nuts.