User Manual

ParSec Reader Installation Manual - Issue:2 - January 1998 - Page 17
determined by the number of pulses detected within this interval.
With switch S9 in position 1, the tag's code will be transmitted immediately it is moved (this is
equivalent to 1 pulse count). If this is too sensitive try another higher setting. The standard
setting for the Static Tag is between 3 and 5 counts.
5. T
ROUBLESHOOTING
5.1. Reader Reset
Switch S15 provides a reader reset and should be used, by pressing it for 1-2 seconds, only if
the reader appears to have “hung up”; symptoms may include
(1) Corrupt or no data output.
(2) No scan response to the RAT.
(3) Irregular LED status.
5.2 No response when Tags are activated
The K
EY
PIC in the reader will only respond to tags with the same company and site codes.
All Newmark readers and tags normally use the company code 01. Demonstration units use
the site code 63.
6. Repair
If for any reason you wish to return the reader for repair or upgrade, before shipping the
reader call the Operations Department at Newmark on [phone] and obtain a
Repair and Service number (RAS No.). When calling, please have the following information
available:
• Reason for return
• Reader serial number
• Our invoice or sales order number - if known
Mark the package with the RAS number and return it to the address on the front page of this
manual.
For readers which are no longer covered by our 12 month warranty, you will need to send us
a new purchase order.