Installation Manual

12
Revision 0.8
Figure 4. Sensor-01 Mounting Plate (shown for reference only)
3.2.1.2 SENSOR-3 MOUNTING PLATE
The Sensor-3 Mounting Plate is a flat piece of aluminum with tabs on the short edges that house an embedded
nut and a captive thumb screw. There are two additional holes used to attach the Sensor-3 Mounting Plate to
the Sensor-3 enclosure using two M5 pan head screws. The tabs should point away from Sensor-3 enclosure
when properly installed, and the M5 screws should be hand tight (see Figure 5 below).