Installation Manual

11
Revision 0.8
3.2.1.1 SENSOR-3 ADAPTER PLATE
The Adapter Plate is C-shaped aluminum piece that is pre-drilled with holes that match a variety of de facto
industry standard hardware. There is an embedded nut on one end of the Adapter Plate, and a captive
thumb screw on the other end. The holes in the Sensor-3 Adapter Plate match the holes in the Sensor-1
Mounting Plate (shown in Figure 4 below), which allows the Sensor-3 Adapter Plate to be used with the
various Bastille Networks ceiling mount methods approved for Sensor-1, including:
• Unistrut
• Threaded rod
• I-Beam
• Etc
See Sensor-1 Installation Manual for details about the above ceiling mount methods.
Figure 3. Sensor-3 Adapter Plate
The Sensor-3 Adapter Plate mounts to a ceiling structure with the bent edges facing down.