Installation Manual

13
Revision 0.6
3.2.1.2 SENSOR-02 MOUNTING PLATE
The Sensor-02 Mounting Plate is a flat piece of aluminum with tabs on the short edges that house an
embedded nut and a captive thumb screw. The hole pattern on the Sensor-02 Adapter Plate is duplicated on
the Sensor-02 Mounting Plate to allow air to flow out of the Sensor-02 enclosure. There are two additional
holes used to attach the Sensor-02 Mounting Plate to the Sensor-02 enclosure using two M5 pan head screws.
The tabs should point away from Sensor-02 enclosure when properly installed, and the M5 screws should be
hand tight (see Figure 5 below).
Figure 5. Sensor-02 Mounting Plate