Material Safety Data Sheet

VII. Control Measures
Engineering Controls
Engineering controls are not necessary under normal use conditions. Local exhaust ventilation should be used if
airborne concentrations exceed 5 mg/M
3
. Enclosures or barriers should be used if splashing is possible.
Work Practices
Work practices should be devised to minimize skin and eye contact.
PERSONAL PROTECTIVE EQUIPMENT
Respiratory Protection
NIOSH approved organic vapor respirators with dust prefilters should be used if airborne concentrations exceed
5 mg/M
3
.
Eyes and Face
Eye and face protection should be used if eye contact is likely.
Hands, Arms, Body
Protective gloves may be used to prevent hand contact.
Other Special Clothing and Equipment
Unknown.
VIII. Safe Handling Precautions
Hygiene Practices
Wash hands with soap and warm water after handling the grease.
Protective measures to be taken during non-routine tasks including equipment maintenance.
Avoid skin and eye contact.
SPILL OR LEAK PROCEDURES
Protective measures to be taken if material is released or spilled.
Persons not wearing protective equipment and clothing should stay out of the spill area. Remove ignition sources
and ventilate area. Small quantities may be absorbed on paper towels. Larger quantities can be shoveled into a
container. Do not allow spill to enter waterways or sewers.
Waste Disposal Method
Dispose in accordance with federal, state, and local laws and regulations.
OTHER HANDLING AND STORAGE PRECAUTIONS
Keep containers closed.