Install Instructions

H91 Model Rev. B Series Shutoff Gas Valve

Part No. BASO-INS-H91MODELREVB, Rev.- www.baso.com

APPLY WRENCH TO THE FLATS

FROM THE BOTTOM OF THE

GAS CONTROL VALVE

Figure 3: Proper Use of Wrench

on Gas Control

**DO NOT USE THE COIL FOR LEVERAGE

WARNING: Risk of Explosion or Fire.

Verify that there are no gas leaks by testing with

appropriate equipment. Never use a match or lighter

to test for the presence of gas. Failure to test

properly can lead to an explosion or fire and may

result in severe personal injury or death.

11. Check for leakage:

a. Shut off the gas at the main manual shutoff

valve and open the pressure connection

between the manual shutoff valve and the H91

Series valve.

b. Connect air tubing with a maximum pressure

of 1-1/2 times the valve’s maximum operating

pressure (as indicated on the valve) to the

opened pressure connection.

c. Paint all valve body connections with a rich

soap and water solution.

If bubbles occur, this is an indication of a leak.

To stop a leak, tighten joints and connections.

Replace the part if the leak cannot be stopped.

If bubbles do not occur, remove the air tubing

and close the pressure connection.

12. Make wiring connections. Refer to the Wiring

section for specific wiring instructions.

13. Perform the Checkout section before leaving the

installation.