User`s manual

I/O Control AW00104701000
72 Basler scout light GigE
8.1.2 Using an Unassigned Input Line to Receive
a User Input Signal
You can use the input line to receive your own, user-generated input signal. The electrical
characteristics of your input signal must meet the requirements shown in the Physical Interface
section of this manual.
You can use the Line Status or Line Status All parameters to monitor the state of the input line that
is receiving the user-defined signal.
For more information about using the Line Status and Line Status All parameters, see Section 8.3.1
on page 81 and Section 8.3.2 on page 81.
When the input line is assigned to receive an ExTrig input signal the input line can’t
be used to receive a user-designed input signal.