User`s manual

AW00104701000 Specifications, Requirements, and Precautions
Basler scout light GigE 19
1.9 Precautions
For more specific information about the lens thread length, see Section 1.5.2 on page 14.
NOTICE
Avoid Dust on the Sensor.
The camera is shipped with a cap on the lens mount. To avoid collecting dust on the camera’s IR
cut filter (color cameras) or sensor (mono cameras), make sure that you always put the cap in
place when there is no lens mounted on the camera.
To further enhance dust protection, the internal space in the camera that contains the imaging
sensor is sealed off from the camera’s other internal spaces.
NOTICE
Lens Thread Length is Limited.
Color models of the camera are equipped with an IR cut filter mounted inside of the C-mount
adapter. The location of this filter limits the length of the threads on any lens you use with the
camera. If a lens with a very long thread length is used, the IR cut filter will be damaged or
destroyed and the camera will no longer operate.
NOTICE
Voltage Outside of Specified Range Can Cause Damage.
If the voltage of the power to the camera is greater than +30.0 VDC damage to the camera can
result. If the voltage is less than +11.3 VDC, the camera may operate erratically.
NOTICE
An Incorrect Plug Can Damage the 12-pin Connector.
The plug on the cable that you attach to the camera’s 12-pin connector must have 12 pins. Use
of a smaller plug, such as one with 10 pins or 8 pins, can damage the pins in the camera’s 12-pin
connector.