User`s manual

AW00104701000 Image Acquisition Control

Basler scout light GigE 145

find that your exposure time is the most restrictive factor on the frame rate. In this case, you

should lower your exposure time. (You may need to compensate for a lower exposure time by

using a brighter light source or increasing the opening of your lens aperture.)

 The frame transmission time will not normally be a restricting factor. But if you are using

multiple cameras and you have set a small packet size or a large inter-packet delay, you may

find that the transmission time is restricting the maximum allowed rate. In this case, you could

increase the packet size or decrease the inter-packet delay. If you are using several cameras

connected to the host PC via a network switch, you could also use a multiport network adapter

in the PC instead of a switch. This would allow you to increase the Ethernet bandwidth

assigned to the camera and thus decrease the transmission time.

For more information about AOI settings, see Section 11.6 on page 185.

For more information on the settings that determine the bandwidth assigned to the camera, see

Section 5.2 on page 46.

Formula 1:

Calculates the maximum frame rate based on the sensor readout time:

Where:

AOI Height = the height of the acquired frames as determined by the AOI Height settings.

The constants C

and C

depend on the camera model as shown in the table below:

Max. Frames/s

(AOI Height + 1) C

×[]C

------------------------------------------------------------------------------=