User`s manual

Physical Interface AW00089316000
62 Basler ace GigE
5.8 Output Line Description
5.8.1 Voltage Requirements
The following voltage requirements apply to the I/O output line (pin 4 of the 6-pin connector):
5.8.2 Characteristics
The camera is equipped with one physical output line designated as Output Line 1. The output line
is accessed via the 6-pin connector on the back of the camera.
As shown in Figure 37, the output line is opto-isolated. See the previous section for the
recommended operating voltages. The absolute maximum voltage is +30.0 VDC. The maximum
current allowed through the output circuit is 50 mA.
A low output signal from the camera results in a non-conducting Q1 transistor in the output circuit.
NOTICE
Voltage outside of the specified range can cause damage.
Note that the recommended voltage range for the output line differs from the recommended
voltage ranges for camera power (see Section 5.5 on page 55) and for the input line (see
Section 5.7.1 on page 57). You must supply power within the specific voltage range.
Note also that the recommended voltage range for the I/O output line of Basler ace GigE cameras
can differ from the recommended voltage ranges for the I/O output lines of other Basler cameras.
You must supply power within the specified voltage range.
Voltage Significance
< +3.3 VDC The I/O output may operate erratically.
+3.3 to +24 VDC Recommended I/O output voltage.
+30.0 VDC Absolute maximum; the camera may be damaged, if the absolute maximum is exceeded.
Table 11: Voltage Requirements for the I/O Output