User`s manual

Index AW00089316000
370 Basler ace GigE
auto functions factory setup ............311
color factory setup
..........................311
high gain factory setup
....................311
standard factory setup
....................311
frame start overtrigger event
.................301
frame start trigger
..................................236
free selection sequence
~ set advance mode
.......................260
G
gain .......................................................209
gain auto
...............................................291
gain raw parameter
...............210, 212, 214
global
~ shutter
..........................................111
gray value
~ adjustment damping
....................295
H
high gain factory setup ..................311, 313
horizontal binning
..................................266
horizontal mirror image
.........................276
I
image distortion .............................270, 273
input line
electrical characteristics
....................58
propagation delay
.............................60
voltage requirements
........................57
L
line status ..............................................249
lookup table
...........................................279
luminance lookup table
.........................279
LUT
.......................................................279
LUT enable parameter
..........................281
LUT index parameter
............................281
M
max height parameter ...........................308
max width parameter
............................308
minimum output pulse width
.................299
mirror image
..........................................276
modes of operation (of auto functions)
.283
N
non-sequence parameter ..................... 233
O
output line
electrical characteristics
................... 62
response time
................................... 65
voltage requirements
........................ 62
P
parameter limits, removing ................... 217
parameter sets
explained
........................................ 311
parameter sets, saving
......................... 314
parameters loaded at startup
................ 316
pin assignments
..................................... 50
pin numbering
......................................... 50
PLC power and I/O cable
................. 52, 54
voltage requirements
.................. 55, 57
R
reduced resolution ........................ 270, 273
remove limits parameter
....................... 217
removing parameter limits
.................... 217
restart
asynchronous
................................. 236
synchronous
................................... 236
reverse X
.............................................. 276
rolling
~ shutter
......................................... 113
S
saving parameter sets .................. 311, 314
sensor height parameter
....................... 308
sensor width parameter
........................ 308
sequence
cycle
............................................... 238
sequence advance mode
..................... 233
sequence parameter
............................ 233
sequence set
........................................ 233
address
........................................... 263
configuration
................... 242, 256, 264
index number
.................................. 235
load
................................................. 237
store
............................... 242, 257, 264