User`s manual

AW00098504000 Physical Interface
Basler ace Camera Link 47
For more information about using the CL Spare bit on your specific type of frame grabber installed
in your system, refer to the documentation for you frame grabber board.
You can also obtain some general information about how this bit is implemented in the Camera Link
interface from the Basler document named Ace Camera Link Information for Frame Grabber
Designers (AW000990xx000). You can obtain the document from the Downloads section of the
Basler website:
www.baslerweb.com
For more information about selecting a camera output signal to act as the source signal for the CL
Spare bit, see Section 6.2 on page 54.
The CL Spare data bit is not available when the camera is set for the 1X8-1Y or
the 1X10-1Y tap geometry.
The CL Spare data bit is not directly accessible by the camera user. The data bit
must be accessed via the frame grabber attached to the camera. Not all frame
grabbers provide users with direct access to this bit. Consult your frame grabber
supplier for more information.