User`s manual

Physical Interface AW00098504000
44 Basler ace Camera Link
5.7.4.3 Response Time
The response times for the GPIO line on the camera when the line is set to operate as an output
are as shown in Figure 16.
Time Delay Rise (TDR) = 40 µs
Rise Time (RT) = 20 µs to 70 µs
Time Delay Fall (TDF) = 0.6 µs
Fall Time (FT) = 0.7 µs to 1.4 µs
The information in this section assumes that the output circuit on your camera is
designed as in the typical voltage output circuit shown in Section 5.7.4.2.
The response times for the output lines on your camera will typically fall into the
ranges specified below. The exact response time for your specific application will
depend on the external resistor and the applied voltage you use.
Time
TDR
RT
TDF
FT
90%
90%
Not to Scale
Level on
Out_1_Ctrl
Voltage Present
on the Camera’s
Output Line
Fig. 16: GPIO Line Output Response Times