User`s manual

Configuring the Camera

BASLER A620

f 4-19

DRAFT

4.4.2 Control and Status Registers

The base address for all camera control and status registers is:

Bus ID, Node ID, FFFF F0F0 0000

In each control and status register description, an “Offset from the Base Address” is provided. This

a byte offset from the above base address. The address of a control and status register equals

the above base address plus the indicated offset.

Values are stated in decimal format except when marked 0x. Values marked as 0x (e.g., 0x123)

are in hexadecimal format. Bit 0 in each register is the most significant bit.

4.4.2.1 Control and Status Registers for Basic Camera Operation

Offset from Base Address: 0x600

Field Bit Description

Frame Rate /

Revision

0 ... 2 If the camera is set for video Format 0, 1 or 2, this field sets the current

video frame rate.

0 = frame rate 0 4 = frame rate 4

1 = frame rate 1 5 = frame rate 5

2 = frame rate 2 6 = frame rate 6

3 = frame rate 3 7 = frame rate 7

Default = 0

Check Section 3.12 to determine the standard frame rates supported

by the A620f.

If the camera is set for Format 7, the setting in this field is ignored.

If the camera is set for Format 6, this field sets the current revision.

(The A620f does not support Format 6.)

---

3 ... 31 Reserved

Offset from Base Address: 0x604

Field Bit Description

Mode 0 ... 2 This field sets the current video mode.

0 = mode 0 4 = mode 4

1 = mode 1 5 = mode 5

2 = mode 2 6 = mode 6

3 = mode 3 7 = mode 7

Default = 0

Check Section 3.12 to determine the video modes supported by the

A620f.

---

3 ... 31 Reserved