User`s manual

Configuring the Camera
BASLER A620
f 4-3
DRAFT
4.4 Implemented Standard Registers
This section includes a description of all DCAM standard registers implemented in the A620f.
4.4.1 Inquiry Registers
The base address for all inquiry registers is:
Bus ID, Node ID, FFFF F0F0 0000
In each inquiry register description, an “Offset from Base Address” is provided. This a byte offset
from the above base address. The address of an inquiry register equals the above base address
plus the indicated offset.
Values are stated in decimal format except when marked 0x. Values marked as 0x (e.g., 0x123)
are in hexadecimal format. Bit 0 in each register is the most significant bit.
4.4.1.1 Initialize Inquiry Register
4.4.1.2 Inquiry Registers for Video Formats
Each bit in the video format inquiry register indicates the availability of a specific format.
0 = format not available 1 = format available
Register Name: Camera Initialize
Offset from Base Address: 0x000
Field Bit Description
Initialize 0 If you set this bit to 1, the camera will reset itself, break any state lock,
and re-initialize itself to factory settings. The bit is self cleared.
---
1 ... 31 Reserved
Register Name: Video Format Inquiry
Offset from Base Address: 0x100
Field Name Bit Description A620f
Value
Format 0
0 VGA non-compressed format 1
Format 1 1 Super VGA non-compressed format (1) 1
Format 2 2 Super VGA non-compressed format (2) 1
Format x 3 ... 5 Reserved ---
Format 6 6 Still image format 0
Format 7 7 Partial image size format 1
--- 8 ... 31 Reserved ---