User`s manual

Smart Features
BASLER A620
f 6-29
DRAFT
Control and Status Registers for the Output Port Configuration Feature
Register Name: Output Port 0 Configuration
Address: See “Determining the Address of Smart Features CSRs” on page 6-4.
CSR GUID: 5A889D7E - 41E5 - 11D8 - 845B - 00105A5BAE55
Position Field Bit Description
0 Presence Inq
(Read only)
0 Presence of the output port 0 configuration fea-
ture
0: Not Available 1: Available
Monitor Inq
(Read only)
1 Presence of the monitor field
0: Not Available 1: Available
Invert Inq
(Read only)
2 Presence of the invert field
0: Not Available 1: Available
User Setting Inq
(Read only)
3 Presence of the user setting field
0: Not Available 1: Available
----- 4 ... 26 Reserved
Source Select
(Read / write)
27 ... 31 Write a value to select a source signal for output
port 0:
0: Integrate Enabled signal
1: Trigger Ready signal
3: User set (state can be set with the User Set-
ting field described below)
4: Strobe
4 Source Select Inq
(Read only)
0 ... 31 If bit n is set, then value n is valid for use in the
Source Select field. For example, if bit 0 is set,
then 0 is a valid value for use in the Source Se-
lect field. If bit 1 is set, then 1 is a valid value for
use in the Source Select field. Etc.
8 ----- 0 ... 30 Reserved
Monitor
(Read only)
31 Shows the current state of the output:
0: Low (non-conducting)
1: High (conducting)
12 ----- 0 ... 30 Reserved
Invert
(Read / write)
31 Enables signal inversion:
0: Do not invert
1: Invert
16 ----- 0 ... 30 Reserved
User Setting
(Read / write)
31 If the Source Select field is set to “user set”, this
field sets the state of the output:
0: Low (non-conducting)
1: High (conducting)
(Sets the state of the output before
the inverter.)
20 ----- 0 ... 31 Reserved