User`s manual

Introduction
1-4 BASLER A620
f
DRAFT
1.5 Environmental Requirements
1.5.1 Temperature and Humidity
Housing temperature during operation: 0° C … + 50° C (+ 32° F … + 122° F)
Humidity during operation: 20% … 80%, relative, non-condensing
1.5.2 Ventilation
Allow sufficient air circulation around the camera to prevent internal heat build-up in your system
and to keep the housing temperature below 50° C. Additional cooling devices such as fans or heat
sinks are not normally required but should be provided if necessary.
1.6 Precautions
To ensure that your warranty remains in force:
Read the manual
Read the manual carefully before using the camera!
Keep foreign matter outside of the camera
Do not open the casing. Touching internal components may damage them.
Be careful not to allow liquid, flammable, or metallic material inside the camera housing. If
operated with any foreign matter inside, the camera may fail or cause a fire.
Electromagnetic Fields
Do not operate the camera in the vicinity of strong electromagnetic fields. Avoid electrostatic
charging.
Transporting
Transport the camera in its original packaging only. Do not discard the packaging.
Cleaning
Avoid cleaning the surface of the CMOS sensor if possible. If you must clean it, use a soft, lint free
cloth dampened with a small quantity of high quality window cleaner. Because electrostatic
discharge can damage the CMOS sensor, you must use a cloth that will not generate static during
cleaning (cotton is a good choice).
To clean the surface of the camera housing, use a soft, dry cloth. To remove severe stains, use a
soft cloth dampened with a small quantity of neutral detergent, then wipe dry.
Do not use volatile solvents such as benzine and thinners; they can damage the surface finish.