User`s manual

Configuring the Camera
4-18
BASLER A600f
DRAFT
Control and Status Registers for the PIO Control Function
The base address for the PIO Control Function control and status registers is:
Bus_ID, Node_ID, FFFF F2F0 00C8
The offset field in the table is the byte offset from the above base address.
* These registers are defined in version 1.31 of the IIDC specification.
Offset Name Notes
000h * PIO_Output Bit 31 sets the state of physical output port 0.
Bit 30 sets the state of physical output port 1.
Bit 29 sets the state of physical output port 2.
Bit 28 sets the state of physical output port 3.
004h *
PIO_Input Bit 31 indicates the current state of physical input port 0.
Bit 30 indicates the current state of physical input port 1.
Bit 29 indicates the current state of physical input port 2.
Bit 28 indicates the current state of physical input port 3.
L
The PIO_Output register will only set the state of physical output ports that are
configured as “User Set” (see Section 5.7.10). For any output ports not configured
as user set, the bit settings in this register will be ignored.