User`s manual

Camera Interface
2-6 Basler A500k
PRELIMINARY
Figure 2-3: FlashOut Signal Timing
Figure 2-4: Flash Trigger Output Schematics
Flash
Out
ExFlash
or
Integrate
Enabled
max = 0.3 µs max = 0.3 µs
max
= 1.3 µs (A501k)
= 1 µs (A503k)
= 1 µs (A504k)
max = 1.3 µs (A501k)
= 1 µs (A503k)
= 1 µs (A504k)
TTL Active High (default)
A TTL Active High output signal is
typically used together with a TTL /
CMOS Logic Device.
The TTL Active High output signal
has the following characteristics:
• High output min. 4.5 V at 10 mA
output load, shortcut current
50 mA (+40 %/- 20 %)
• Low output max. 0.5 V at -10 mA
output load, shortcut current
-50 mA (+40 %/- 20 %)
Low Side Switch
(Open Collector)
When you select this output signal
variant, the upper transistor is deac-
tivated, which is shown by grayed
lines in the schematic.
The schematic shows a sample cir-
cuit for your flash device.
Select your flash device to ensure
that the maximum output current
never exceeds 50 mA.
High Side Switch
When you select this output signal
variant, the lower transistor is deac-
tivated, which is shown by grayed
lines in the schematic.
The schematic shows a sample cir-
cuit for your flash device.
Select your flash device to ensure
that the maximum output current
never exceeds 50 mA.