User`s manual

Index
230 Basler ace Camera Link
electrostatic discharge ...............................8
EMI.............................................................8
environmental requirements ......................9
error detection........................................206
ESD............................................................8
exposure active signal ...........................107
exposure auto ........................................200
exposure modes
timed ..................................................85
trigger width .......................................87
exposure overlap time max abs
parameter.........................................87
, 104
exposure start delay...............................113
exposure time
controlling with an external
trigger signal ......................................84
setting ................................................92
F
factory setup ..........................................215
auto functions factory setup .............215
color factory setup............................215
high gain factory setup.....................215
standard factory setup .....................215
firmware version parameter ...................212
frame cycle signal ..................................110
frame rate
and AOI size ....................................115
controlling with an external
trigger signal ......................................84
increasing the max allowed..............117
maximum allowed ............................115
frame readout time.................................113
frame start trigger
details.................................................76
introduction ........................................64
frame start trigger delay ...........................88
frame start trigger mode parameter .........76
frame transmission time .........................113
frame trigger wait signal.........................102
free run...................................................119
functional description ...............................21
G
gain auto ................................................197
gamma correction ..................................131
H
hardware trigger
acquisition start ................................. 73
frame start ......................................... 84
heat dissipation.......................................... 9
high gain factory setup .......................... 215
horizontal binning .................................. 174
humidity ..................................................... 9
I
image area of interest............................ 158
increasing the max allowed
frame rate .............................................. 117
input line
electrical characteristics .................... 35
invert.................................................. 51
propagation delay.............................. 37
using as a source signal.................... 48
voltage requirements......................... 34
integrate enabled signal ................ 107
, 110
invert
input line............................................ 51
output line.......................................... 57
IP30 ........................................................... 6
IR-cut filter ..................................... 5
, 7, 129
L
LED indicator................................... 32, 206
lens adapter........................................... 2
, 3
lens thread length...................................... 7
line inverter parameter....................... 51
, 58
line source
parameter ................ 54
, 101, 105, 108, 111
line status parameter......................... 59
, 61
LUT (luminance lookup table)................ 182
M
max height parameter............................ 212
max lens thread length .............................. 7
max width parameter............................. 212
maximum allowed frame rate ................ 115
mirror imaging........................................ 177
models....................................................... 1
modes of operation
(of auto functions).................................. 188